Commando ALA550 Manual do Utilizador descarregar pdf (Página 16)

1/2/02

ALA550 

Turn the ignition switch from OFF to ON, and within 10 seconds push valet switch, the siren will stop and

the system disarmed

Note: If you use password pin code to double protect the vehicle security, you will need to use it to

completely disarm the system.

O. DOME LIGHT CONVENIENCE DELAY & SUPERVISION

The alarm with a unique feature which will turn on your vehicle dome light as following:

1. Upon disarming, the interior lights will remain on for 30 seconds.

2. If the vehicle is intruded, the interior light will flash for the same duration as the siren.

Note: Turn ON the ignition switch or arm the alarm will turn off the dome light.

P. IGNITION CONTROL POWER DOOR LOCK SAFETY SYSTEM. (See Feature II – 3/4

Programming.).

a. Safety lock with ignition switch and vehicle’s door. (Factory default setting)

1. Turn the ignition switch on and close all vehicle’s door. After 3 seconds, the system will automatically

lock the central locking system.

2. Turn the ignition switch off . The system will automatically unlock the central locking system.

b. Safety lock with ignition switch and handbrake.

Connect the black/white wire to the handbrake switch for this application and programmed the “Safety

lock with handbrake” on feature programming.

1. Turn the ignition switch on, close all vehicles’ door and release the handbrake. The system will

automatically lock the central locking system.

2. While the ignition switches on, Re-open and close the vehicle’s door and release the handbrake, The

system will automatically lock the central locking system.

3. Turn the ignition switch off and pulling up the handbrake. The system will automatically unlock the

central locking system.

Q. POWER ON MEMONRY:

This security system is equipped with circuitry that will allow the unit to remember its alarm state if the

power is lost and then reconnected.

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions.

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause undesired

operation.

T0723

1 2 ... 11 12 13 14 15 16

Sem comentários

Commando ALA550 Manual do Utilizador Página 16